According to the commonly used inspection well mould in construction, its characteristics and structure are all around the data of circle, inner diameter, wall thickness, height and so on, while the production of sewage inspection well mould is based on the specific production mode of blanking and welding, so through the comparison of different schemes, such as cast-in-place concrete production. Sewage wells often cut holes at the bottom, while prefabricated sewage wells use connection holes (sometimes called plugs or reserved holes) and so on. The difference between the two production modes makes the production plan of sewage well mould changed accordingly. When inspecting the characteristics and structure of sewage well mould, it often depends on the detailed description given by each order, such as the size of inner diameter, the thickness of concrete wall, the number of sets needed for each type, etc. These basic data are the same on a certain basis, but they involve different municipal pipeline projects or different rain and sewage diversion projects, there will be different heights of wellbore. Whether sewage wells or other inspection wells, with the technical support of Lichang Mould, depending on the production capacity of workers to complete the needs of using inspection wells template in each area, to ensure the smooth development of each project.
Detailed data of inspection well mould are also stipulated. This is a well room for inspectors or professional equipment testing. Most of them are not water-efficient. Compared with the previous brick and plastic wells, the bearing capacity has changed qualitatively, and the construction efficiency of one-time concrete shaping is faster. The steel formwork welding is used in the mould of drainage inspection well. Although the cost has been improved, the quality change should be noticed. The advantages of the steel mould are obvious. The compactness of the concrete prefabricated product is also very high, which meets the requirements of the joint design between the inspection well and the pipeline. According to the size of the drainage pipeline. Sometimes the design of drainage wells is different because of the difference of small number and quantity. This is to make the drainage effect better. Some of them are also divided into upper and lower wellbore components. The part is used to drive the overall fluidity better. The water intake is located between the wellbore and the wellbore, and its function is to adjust the diameter of the wellbore. So pressure can stand the test. After the completion of the drainage inspection well, we should pass the inspection and then use, its quality specifications and shapes should meet the requirements.